15
9.10 Setting DHCP Mode
The VMV-402-SH may be operated in DHCP mode. That is, the address is not Static but is, instead, set
automatically by a router on the network. When DHCP mode is enabled, the current IP address may
change. As mentioned in the sections above, it is best to connect to the unit fi rst with a Static address.
In this way, the control app learns the specifi c MAC address of this particular unit. Once it knows the
MAC address, the control app will be able to fi nd the device on a network even if the IP address has
been changed by a router.
The procedure to change to DHCP mode is the same as setting a Static address except that the
DHCP Enable box must be checked before clicking the Apply button.
At this point, the VMV-402-SH will restart (indicated by all front panel buttons lighting). Close and
restart the control app. Allow at least one full minute for the mode change to complete.
On the Port Setting page, change Port Selection to DHCP and click Connect. At this point, the
IP Address shown is unrelated to the address that is actually in use, the window does not update
automatically.
9.11 Using 3rd Party Controllers
The VMV-402-SH may be controlled remotely via Ethernet, USB or IR optical.
Control codes and operational tips may be found on the Marshall-USA.com website at:
http://www.marshall-usa.com/pdf/VMV-402-Remote-Control-Protocol.pdf
To Next Page
Loading...