5.5.14 Manual array editing (experts only!!!)
Should you wish to ignore ViewPoint
tm
’s accurate coverage advice, continue with
great caution, as follows:
Click on the Manual button (in Venue view) to manually edit splay angles and the
array tilt angle.
1) Position the cross-hair over the dark blue squares at the end of each ray until
the box turns red.
2) Use the left and right mouse buttons to increase or decrease the array tilt (top
cabinet only) or inter-cabinet splay angles of the cabinets below.
Alternatively . . .
1) Click on the splay angle to be altered to select a cabinet.
2) Move the mouse pointer into the top half of the screen.
To Next Page
Loading...
