5.5.16 Processor page
The Processor page shows a controller-to-amplifier patch table and indicates which
controller settings to use for the design.
The page also shows power amplifier rack layouts to ensure that the amplifiers share
the power demand adequately (see Quick Start sections for advice on rack layouts and
mains distribution). Move your mouse cursor over the greyed out amplifier racks to
see further rack details.
Historically, array cabinets have been numbered from top to bottom (see Quick Start
sections). W8L and W8LC line array section impedances are all 8 ohms and usually
driven in pairs so that each power amplifier channel sees a 4 ohm load. W8LM line
array section impedances are about 13 ohms and are usually driven in fours to present
a 3.25 ohm load.
To Next Page
Loading...
