Safety Information
The following symbols are used to identify important safety information on the product and in this manual:
.WARNING! Risk Group 3 LED product according to EN 62471. Do not look into the beam at a
distance of less than 8.7 meters (28 ft. 7 ins.) from the front surface of the product. Do not view the
light output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. If you have questions about how to
operate the fixture safely, please contact your Martin supplier or call the Martin 24-hour service hotline on
+45 8740 0000, or in the USA on 1-888-tech-180.
PROTECTION FROM ELECTRIC SHOCK
• Disconnect the fixture from AC power before removing or installing any cover or part – including fuses –
and when not in use.
• The fixture has double-pole/neutral fusing. If it is not completely disconnected from AC power, parts of the
fixture may remain live even if one of the two mains fuses has blown.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect the fixture to AC power using a listed, 3-conductor, minimum 1.5 mm
2
or 16 AWG cable that is
rated minimum 10 amp, hard usage. Suitable cable jacket types include SJT, ST, STW, SEO, SEOW and
STO.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Isolate the fixture from power immediately if any power connector, power cable, seal, cover or other
component is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power
until repairs have been completed.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
WARNING!
Safety hazard.
Risk of severe
injury or death.
WARNING!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING!
LED Light
emission. Risk of
eye injury.
WARNING!
Refer to user
manual.
To Next Page
Loading...
Need help?
General
