Martin MAC Encore Performance CLD - Control Panel Menu Structure

Control panel menus 27
Control panel menus
MAC Encore Performance firmware version 1.0.0.
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
DMX ADDRESS 1 – XXX
DMX address (default address = 1). The
DMX address range is limited so that the
fixture will always have enough DMX
channels within the 512 available.
FIXTURE ID 0 – 9999 User-settable fixture ID number
0
PERSONALITY
PA N /T ILT
PAN INVERT ON/OFF Inverse DMX pan control: right → left
TILT INVERT ON/OFF Inverse DMX tilt control: down → up
FOLLOWSPOT
MODE
ON/OFF Enable followspot mode
LIMIT PAN/TILT
LIMIT ENABLE ->
ON/OFF
Enable pan and tilt limits
PA N MI N - >
degrees
Set minimum limit for pan angle
PAN MAX ->
degrees
Set maximum limit for pan angle
TILT MIN ->
degrees
Set minimum limit for tilt angle
TILT MAX ->
degrees
Set maximum limit for tilt angle
SPEED
PA N /T ILT
FAST Optimize pan/tilt movement for speed
SMOOTH
Optimize pan/tilt movement for
smoothness
EFFECT
FOLLOW P/T
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
FAST Optimize effects movement for speed
SLOW
Optimize effects movement for
smoothness
DIMMER CURVE
LINEAR Optically linear dimming curve
SQUARE LAW Square law dimming curve
INV SQ LAW Inverse square law dimming curve
S-CURVE
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming curve)
TUNGSTEN
EMULATOR
ON/OFF Enable tungsten lamp emulation
ALTERNATE
COLOR TEMP
ON/OFF
Applies alternative color temperature: sets
CLD fixture to warm white and WRM
fixture to cold white by deploying CTC
flags
FOCUS
TRACKING
ENABLED
Focus self-adjusts depending on zoom
angle
DISABLED Focus remains at distance set via DMX
VIDEO
TRACKING
ENABLED
Color fading optimized for speed of color
changes
DISABLED Color fading optimized for smoothness
DMX RESET
ON Fixture can be reset via DMX
OFF
Fixture cannot be reset via DMX (can be
overridden: see DMX protocol)
Table 3: Control menus