Service and display messages 31
Service and display messages
The MAC Encore Performance gives service and maintenance information by displaying a large 3- or
4-character short code and a smaller full-text message in the fixture’s display. The short code is visible at a
distance, allowing easier reading with the fixture still in the rig, for example, while the full-text message gives
more detailed information.
Warning messages
Warning messages indicate that either:
• problems might appear in the future if no action is taken, or
• the user needs to pay special attention to a function or procedure when working with the fixture.
The MAC Encore Performance communicates warnings as follows:
• Warning codes are shown continuously in the display and disappear when the user reacts to the warning.
• If more than one warning is detected, all warnings are displayed in sequence.
• If the display is inactive, the fixture’s status LED (see Figure 4 on page 10) flashes orange to indicate that
there is a warning. Activating the display will show the warning.
The possible warning messages are listed in Table 4 below
:
Short code
Long message and explanation
BANK
BANK NO ACCESS
Error unpacking firmware bank during/after software upload. Fixture will continue to operate on
existing firmware. Warning message is cleared by a successful software upload or at the next
power off/on cycle.
BETW
BEAM TEMP HIGH
Beam temperature sensor detects abnormally high operating temperature.*
CMTW
CMY TEMP HIGH
CMY module temperature sensor detects abnormally high operating temperature.*
DCTW
DC TEMP HIGH
DC PCB sensor detects abnormally high operating temperature.*
EFTW
EFF TMP HIGH
Effects module temperature sensor detects abnormally high operating temperature.*
FRTW
FRAMING TMP HIGH
Framing module temperature sensor detects abnormally high operating temperature.*
G11M
GOBO 1-1 MISSING
Gobo 1 not detected on rotating gobo wheel.
G12M
GOBO 1-2 MISSING
Gobo 2 not detected on rotating gobo wheel.
G13M
GOBO 1-3 MISSING
Gobo 3 not detected on rotating gobo wheel.
G14M
GOBO 1-4 MISSING
Gobo 4 not detected on rotating gobo wheel.
G15M
GOBO 1-5 MISSING
Gobo 5 not detected on rotating gobo wheel.
LDTW
LED DRV TMP HIGH
LED driver temperature sensor detects abnormally high operating temperature.*
PFTW
PFC TEMP HIGH
PFC unit temperature sensor detects abnormally high operating temperature.*
PTTW
PT TEMP HIGH
Pan/tilt PCB sensor detects abnormally high operating temperature.*
Table 4: Warning messages
To Next Page
Loading...
