Martin MAC Encore Performance CLD - Page 28

28 MAC Encore Performance User Guide
PERSONALITY
(continued)
EFFECT
SHORTCUT
ON
Effects take shortest route during
changes, crossing open positions if
necessary
OFF
Effects avoid open positions during effects
changes
COOLING MODE
REGULATED FANS
Fans optimized for light intensity
(temperature controlled by regulating
fan speed, light output unaffected)
FULL
Fans set to full/medium/low/ultra-low
constant speed, fixture temperature
controlled by regulating light output.
MEDIUM
LOW
ULTRA-LOW
DISPLAY
DISPLAY SLEEP
ON Display remains permanently on
2 MINUTES
Display goes into sleep mode 2 minutes
after last key press
5 MINUTES
Display goes into sleep mode 5 minutes
after last key press
10 MINUTES
Display goes into sleep mode 10 minutes
after last key press
DISPLAY
INTENSITY
10 ... 100 Set display intensity in % (default = 100)
DISPLAY
ROTATION
NORMAL /
ROTATE 180
Display orientation normal or rotated 180°
DISPLAY
CONTRAST
1 ...100 Adjust display contrast (default = 41)
ERROR MODE
NORMAL
Enable error messages and warnings in
display
SILENT
Disable error messages and warnings in
display (status LED will still light to indicate
fixture status if error has been detected or
fixture has a warning)
HIBERNATION
MODE
OFF Disable hibernation mode
ON
Enable hibernation mode (light output and
motor operation set to zero)
DEFAULT
SETTINGS
FACTORY
DEFAULT
LOAD
ARE YOU SURE?
YES/NO
Return all settings (except calibrations) to
factory defaults
CUSTOM 1
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 1
SAVE
ARE YOU SURE?
YES/NO
Save fixture’s current settings as Custom
Settings 1
CUSTOM 2
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 2
SAVE
ARE YOU SURE?
YES/NO
Save fixture’s current settings as Custom
Settings 2
CUSTOM 3
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 3
SAVE
ARE YOU SURE?
YES/NO
Save fixture’s current settings as Custom
Settings 3
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 3: Control menus