Martin MAC Encore Performance - Removing the Multimodule

Field engineering change order
5 of 7MAC Encore Performance - How to replace the animation wheel, number 15122017,
date 15-12-2017, revision A
Removing the multimodule
1. Remove the head covers.
2. Remove the front side covers.
3. Place the xture with the front lens pointing
downwards the base.
4. Lock the tilt function (1) in this position.
NOTE! The focus lens will slide out of the
multimodule and down towards the front lens
which make it possible to remove the multimodule.
Figure 4: Locking the tilt function
1
1. Loosen the four screws (2) that hold the
multimodule.
2. Disconnect the CAN BUS and the DC power to
the distribution board (3).
Figure 5: Disconnecting CAN BUS and DC power
2
2
2
3
Figure 6: Replacing the multimodule
1. Replace the multimodule (4).
2. Follow the procedure in reverse order.
4