Martin MAC Encore Performance - Replacing the Animation Wheel

Field engineering change order
6 of 7MAC Encore Performance - How to replace the animation wheel, number 15122017,
date 15-12-2017, revision A
Figure 7: Loosening the ve Torx20 screws
Figure 8: Placing the framing module
Figure 9: Aligning indexing marks
Replacing the animation wheel
1. Remove the head covers.
2. Remove the front side covers.
3. Remove the multimodule. See “Removing the
multimodule” on page 5.
4. Loosen the ve Torx20 screws (1).
5. Place the framing module (2) next to the gobo and
effect module (3).
6. Gently loosen the magnetic holder (4) with a small
atheaded screwdriver.
7. Replace the animation wheel (5).
NOTE! Make sure that the indexing marks (6) are
aligned.
8. Follow the procedure reverse order.
1
2
3
4
5
5
6
6