Why does my Martin MAC Viper Performance show a lamp error?
If your Martin Lighting Equipment displays a lamp error message and there is no light, the lamp may be blown, not installed, or the lamp access door safety switch might be open. Disconnect the fixture from power and replace or install the lamp. Check that the lamp access door is fully seated and locked in place.
What to do if the lamp cuts out intermittently on Martin MAC Viper Performance?
If the lamp in your Martin Lighting Equipment cuts out intermittently, the fixture may be too hot. Allow the fixture to cool down, clean it, and reduce the ambient temperature.
What causes timeout error after Martin MAC Viper Performance reset?
If you get a timeout error after resetting your Martin Lighting Equipment, it may be that the effect requires mechanical adjustment. Contact Martin™ Service or an authorized Martin™ service partner.
What to do if Martin MAC Viper Performance fixtures respond erratically?
If Martin Lighting Equipment fixtures reset correctly but respond erratically, it might be due to a bad data link. Inspect connections and cables, correct poor connections, and repair or replace damaged cables. It could also be that the data link isn't terminated, so insert a DMX termination plug in the data output socket of the last fixture on the data link. Check the fixture address and protocol settings. If one of the fixtures is defective and disturbing data transmission, unplug the XLR in and out connectors and connect them directly together to bypass one fixture at a time until normal operation is regained. Have the fixture serviced by a qualified technician.
How to troubleshoot completely dead Martin MAC Viper Performance Lighting Equipment?
If one or more Martin Lighting Equipment fixtures are completely dead, first check that power is switched on and the cables are plugged in. If the issue persists, it may be due to a blown fuse or an internal fault. In this case, contact Martin™ Service or an authorized service partner for assistance.
Why does the mechanical effect lose position on Martin MAC Viper Performance Lighting Equipment?
If the mechanical effect loses position on your Martin Lighting Equipment, it could be that the mechanical train requires cleaning, adjustment, or lubrication. Contact Martin™ Service or an authorized Martin™ service partner.
General| Color Temperature | 6000K |
|---|---|
| Focus | Motorized |
| Iris | Motorized |
| Animation Wheel | Yes |
| Pan Range | 540° |
| Tilt Range | 270° |
| Control Protocols | DMX512, RDM |
| Type | Moving Head |
| Gobo Wheels | 2 rotating gobo wheels |
| Color Wheels | 2 color wheels |
| Frost | Yes |
| Strobe Effect | Yes |
| Dimmer | Electronic |
| Framing Shutters | 4 rotating framing shutters with 360° rotation |
| Weight | 34 kg (75 lbs) |
To Next Page
