2 Martin MAC Viper Quadray™ Module Installation and DMX Control Guide
Important! Make sure that the front of the head does not face the sun or any other strong light
source directly for longer than a few seconds at any time. Lenses can focus the sun's rays
inside the fixture, causing internal damage and creating a possible fire risk
Important! Do not use concentrated alcohol solutions, abrasive products or solvents to clean
lens accessories. If wiping with a soft, lint-free cloth dampened with distilled water is not
effective, damp the cloth with distilled water containing 20% isopropyl alcohol in solution.
Introduction
This guide explains how to install the Martin MAC Viper™ Beam Kit, P/N 91614053, on a Martin MAC Viper
AirFX™ fixture.
Installing a front lens accessory kit takes only a few minutes. If you keep the standard components that you
remove when you install the lens, it can be uninstalled and the fixture returned to standard configuration at any
time.
Preparation
The MAC Viper Beam Kit contains the following items:
• Beam lens
• Mounting collar with attached multiconnector and Beam Kit
safety wire
• This Installation Guide
Remove any adhesive tape that is applied to the components
in the kit to avoid loss or damage during transport.
Keep the protective packaging supplied with the kit for
possible re-use.
Software compatibility and tilt limits
MAC Viper AirFX firmware version 1.3.0 or later must be installed before installing the Beam Kit. The latest
version of the MAC Viper AirFX firmware is available for download from the MAC Viper AirFX Product Support
page on the Martin™ website at www.martin.com
When firmware version 1.3.0 is installed and the Beam Kit’s multiconnector is connected to its socket in the head,
the MAC Viper AirFX recognizes that the Beam Kit is installed and limits tilt range by 10° at each end so that the
head cannot collide with the base. Total tilt range with the Beam Kit installed is 254°.
To Next Page
Loading...
