Marunaka V241LPS - Safety Guard Assembly

[5] SAFETY GUARD ASSEMBLY
- 6 -
1. For safety reasons, it is imperative that the unit is used
with the correct guard when fitted with a grass cutting
blade. (Fig. 5-1)
Our standard tightening torque of bolt, screw and nut is as
follows:
Please be careful not to tighten them too tightly.
N.B. Bolt of grease-up port on gearcasing must be tightened
at 3.6 daN･m torque.
2. For a safety reasons, it is imperative that the unit is used
with the correct guard when fitted with a nylon head. (Fig.
5-2)
Use only manufacturer’s original blades.
Only use blades or nylon string heads clearly marked with
a maximum R.P.M. speed of at least 10,000 R.P.M.
Follow the fitting instructions carefully
Fig.5-1
Size
M4
M5
M6
M8
M10
Torque (daN･m)
1.6
3.1
5.1
12.2
24.5
Fig.5-2