Marunaka V241LPS - Harness Handling Method

[10] HARNESS HANDLING METHOD
- 12 -
In normal use of the reaper, set the harness side hook on the
hanger strap stem securely before starting the work. This
applies to both single and double harness. (Fig. 10-1)
For the harness fitting method, see Fig. 10-2.
Fi
g
.10-3
In the case of an emergency pull up the belt (red), and the
total machine can be separated from the harness. Be careful
not to operate the belt carelessly except for a case of
emergency. (Fig. 10-3)
Fi
g
.10-1
Fig.10-2