― GB-8 ―
Brushcutter Blade
1. Remove the blade nut, stabilizer and clamping washer from the attaching shaft out of the gearcase.
Note: The blade nut has left-hand thread.
2. Install the brushcutter blade onto the boss adapter, then
reinstall the clamping washer, stabilizer and blade nut.
3. Align the hole in the boss adapter with the guide hole in the
gearcase.
4. Insert theφ6mm pin into the hole in the boss adapter and
the hole in the gearcase to lock the attaching shaft.
5. Tighten the blade nut.
6. Remove theφ6mm pin from the boss adapter and gearcase.
Installing Blade Cover
Attach the blade cover to the brushcutter blade as shown.
Brushcutter
Blade
Blade Cove
CAUTION
POTENTIAL HAZARD
・Brushcutter blade is sharp.
WHAT CAN HAPPEN
・Contact with sharp blade can cause serious personal
injury.
・An unprotected blade is subject to damage.
HOW TO AVOID THE HAZARD
・Keep the blade cover on the blade when the Brushcutter
is not use. This will protect persons from injury from
blade contact, and will protect the blade from damage.
WARNING
POTENTIAL HAZARD
・If the Brushcutter blade is not adequately tightened, it can come loose from the Brushcutter
during use.
WHAT CAN HAPPEN
・This may cause damage to property or personal injury.
HOW TO AVOID THE HAZARD
・Make sure the Brushcutter blade is securely fastened to the attaching shaft in the gearcase.
CAUTION
POTENTIAL HAZARD
・Brushcutter blade is sharp.
WHAT CAN HAPPEN
・Contact with sharp blade can cause personal injury.
HOW TO AVOID THE HAZARD
・Wear gloves when you handle the blade.
Brushcutter Blade
Washe
Left-hand
thread
Gearcase
Boss
Ada
To Next Page
Loading...
