EasyManua.ls Logo

Mase Generators PD 10 S - USING THE GENERATOR; Preliminary Checks; Fuelling Procedures; Battery Handling

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 21
PD 10 S - PD 10.6 S
GB
GB
4 USING THE GENERATOR
4.1 PRELIMINARY CHECKS
Before beginning with any starting procedure, it is
extremely important to become «familiar» with the
generator and its controls. Furthermore, a visual
inspection must be carried out on the machine and the
installation.
Any source of potential or real danger must be eliminated
before proceeding.
- Identify the position of the emergency stop buttons,
switches and other emergency systems on the generator.
- Learn the special emergency procedures relative to the
installation in question.
- Identify the position of the fire extinguisher or other
protection and emergency devices and learn their
functioning.
- Identify any sources of danger such as fuel, engine oil
or acid solution leaks, condensate in the drip caps, high
voltage, high pressure.
- Ensure that the generator is clean and that the
surrounding areas are clean and free of obstacles.
- Check that there are no obstructions in the inlets and
ventilation ducts.
- Check that the exhaust pipe is not oriented against
obstacles, or make sure that these are at least two
metres away.
- Check that the earth connection has been carried out
properly.
At first starting of the generator, after having done any
type of maintenance work, it is always good practice to
check:
- the oil level by means of the dipstick (paragraph
"maintenance");
- that all the electrical utilities are off so that the
generator is not started on load;
- that the fuel pipes are undamaged and properly
connected;
- that there are no electrical connections in a bad state.
4.2 FUELLING
Refuelling must be carried out with extreme care, ensuring
that fuel does not overflow from the engine tank and
respecting the maximum level.
When refuelling has been completed, carefully close the
fillercap.
Fuel is toxic and inflammable and
must therefore be kept in special airtight containers
and stored in inaccessible places.
- Refuelling must be carried out with the generator
off and the key selector in position "0" (STOP)
- Do not smoke and do not use open flames during
refuelling.
- Refuel in well-ventilated places.
- Avoid contact of fuel with the skin and do not
inhale the fumes.
4.3 BATTERY
The generator is supplied with a battery without acid .
Battery fluid is a corrosive acid,
extremely harmful to the skin.
Do not cause short-circuits by placing keys or tools
on the batteries or on the cable fittings.
Have the battery activated by staff prepared with
sulphuric acid for batteries and the appropriate tools.
- Do not disconnect the battery when the generator is
running; the battery charger alternator and the
electronic equipment may irreparably be damaged.
- Respect + / - polarity when connecting; failing this
will cause a short-circuit when starting, which will
irremediably damage the electronic equipment.
The terminals and the connections
must always be maintained dry and clean; to prevent
oxidation, clean and smear the terminals with a film
of vaseline.

Table of Contents

Related product manuals