- 28
PD 10 S - PD 10.6 S
GB
GB
8 TRANSPORT, STORAGE, LIFTING AND HANDLING
8.1 TRANSPORT AND STORAGE
Packaging: Supplied directly by Mase Generators.
The total weight of the packed generator is given in Paragraph 2.4 “Table of technical characteristics”.
It is strictly prohibited to pollute the environment with the packaging
Transport: During transport the generator (with or without packaging) must be protected against atmospheric
agents, it must not be turned upside down and must be protected against knocks. The generator must be transported
without fuel to prevent leaks during travel.
Storage: The generator must be stored in horizontal position and away from atmospheric agents and humidity.
8.2 LIFTING AND HANDLING
All the lifting operations must be carried out by personnel specialised in this type of work, such as truck
drivers, crane drivers, slingers.
The operator is considered responsible for using the
correct machine slinging and lifting technique.
8.2.1 LIFTING AND HANDLING WITH CRANE
The machine must be lifted and handled with the systems
indicated in the picture. Check that the hoisting cables or
chains are homologated and of sufficient capacity, and
also check the minimum cable length. Always use the
eyebolts provided by the manufacturer and always marked
with a pictogram.
ALWAYS TAKE THESE PRECAUTIONS WHEN
LIFTING THE GENERATOR:
Do not swing suspended loads.
Never leave the load unattended.
Lower the generator to the ground very slowly.
Always maintain the safety distance.
The centre of gravity of the generator corresponds
to about the centre of its geometrical volume.
8.2.2 LIFTING AND HANDLING WITH FORKLIFT TRUCK
Use a forklift truck with wide forks and of adequate
capacity and lift in a barycentric position (which
corresponds to about the centre of its geometrical
volume).
The trailer version cannot be lifted with a forklift.
To Next Page
Loading...
