Mase Generators PD 10 S - Starting the Generator; Operating the Generator; Stopping the Generator; Emergency Stop Function

- 22
PD 10 S - PD 10.6 S
GB
GB
1
STARTSTOP
ON
E
M
P
T
S
O
E
N
R
E
G
C
Y
4.4 STARTING
Before starting the generator check that all the utilities
are off to prevent putting the still cold engine under
stress.
Proceed with starting by turning the START key ( ref.1)
clockwise by one click (to the ON position). Then turn
the ignition key to START and release it only when the
engine has started, taking care not to exceed more than
5 seconds for each attempt.
All the protections will be activated when starting the
generator and in case of malfunctioning, the generator is
stopped and the fault signalled by the relevant warning
light coming on.
4.5 USING THE GENERATOR
Before powering any utility, leave the engine to run
without applied load for at least five minutes so that it
gradually reaches the operating temperature. This will
guarantee longer life of the engine and eliminate the risk
of seizures.
The available power is as indicated on the adhesive label
carrying the technical characteristics / fixed on the
machine and shown in detail in the table of technical
characteristics paragraph 2.4.
The sum of absorption of all the
utilities connected to the generator must never exceed
the continuous power value of the generator.
4.6 STOPPING
The generator is stopped by turning the ignition key
completely anticlockwise to the STOP position.
Before stopping it, it is recommended to run it for a few
minutes without applied load so that the internal
temperatures of the engine and alternator are gradually
reduced.
4.7 EMERGENCY STOP
For an emergency stop of the generator press the
"mushroom-head" emergency stop button.
Having removed the causes that determined the need for
an emergency stop, release the emergency stop button
in order to return to the operating conditions.