Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual Page 166 of 195 Page 166 of 195
masTER T-Sync Model MTS200 device can be configured remotely using Serial port, SSH, Telnet and
Webserver mode. However, the configuration through Serial port, SSH and telnet is done by running
“start” utility after taking access of unit console command line interface.
For configuration through Webserver, user need to enter the IP address in web browser software as
explained below:
For HTTP connection with
1. MTS200: http://192.168.100.153 on IPv4
2. MTS200: http://[fdc2:7142:77b7:0:1eba:8cff:fee5:c115] on IPv6
For HTTPS connection with
1. MTS200: https://192.168.100.153 on IPv4
2. MTS200: https://[fdc2:7142:77b7:0:1eba:8cff:fee5:c115] on IPv6
For HTTPS connection, user will be prompted for accepting SSL certificate of MTS200, which user have
to accept as SSL certificates for https in MTS200 are self signed certificate.
Once, user give above address in web browser software, login page of MTS200 page will open as shown
below.
To Next Page