57
To surface clean the chip and wireless receiver:
1. Wipe all surfaces of the chip and wireless receiver with one of the following:
a. 70% Isopropyl alcohol
b. 10% (1:10) chlorine bleach to water solution
c. Quaternary ammonium chloride solution
2. Inspect for visible debris and repeat the above cleaning step as needed.
3. Dry cleaned parts before use.
CAUTIONS:
• To avoid permanent damage to the chip and wireless receiver, do not use undiluted bleach
(5% - 5.25% sodium hypochlorite) or any other cleaning solution not recommended.
• Do not immerse the chip and wireless receiver in any liquid solution.
• Do not sterilize by irradiation, steam, autoclave or ethylene oxide.
Masimo Sensor Cleaning
ALL TBD
WARNING: Before cleaning, make sure the sensor and chip are not applied to the hand.
To surface clean the chip and wireless receiver:
1. Wipe all surfaces of the chip and wireless receiver with one of the following:
a. 70% Isopropyl alcohol
b. 10% (1:10) chlorine bleach to water solution
c. Quaternary ammonium chloride solution
2. Inspect for visible debris and repeat the above cleaning step as needed.
3. Dry cleaned parts before use.CAUTIONS:
• To avoid permanent damage to the chip and wireless receiver, do not use undiluted bleach
(5% - 5.25% sodium hypochlorite) or any other cleaning solution not recommended.
• Do not immerse the chip and wireless receiver in any liquid solution.
• Do not sterilize by irradiation, steam, autoclave or ethylene oxide.
Customer Support
For answers to frequently asked questions (FAQ's) and product support, along with troubleshooting for
your Masimo Stork product, please go to www.mymasimo.co.uk/safetynet-alert or email
customercare@masimo.com.
To Next Page