Masport inbuilt gas fires User Manual

Masport Inbuilt Gas Fireplace - 16 -
obstructed. During the annual service call, the
burner should be removed from the burner tray
and cleaned. Replace the embers but do not block
the air slots.
4) Clean the fan of any lint or foreign matter.
5) After the above steps, check the pilot flames
(Piccolo only), there should be three strong flames
approx. 19 mm long - 1 flame to the rear burner, 1
to the ignition electrode and 1 to the thermocouple.
6) Check the operation of the thermostat (if fitted) by
turning its control point above and below ambient
room temperature and checking the response of
the fire.
Other points to be checked after completing the
above:-
Thermocouple generation
Gas consumption rate
Carbon dioxide content in the combustion products
Flue operation.
Log Replacement
The unit should never be used with broken logs. Turn
off the gas valve and allow the unit to cool before
removing the glass to carefully remove the logs. The
pilot light generates enough heat to burn someone. If
for any reason a log should need replacement, you
must use the proper replacement log. The position of
these logs must be as shown in the diagram on page
12.
Note: Improper positioning of logs may create
carbon build-up and will alter the unit’s
performance. Malfunctioning due to improper log
placement is not covered under warranty.
Glass Gasket
If the glass gasket requires replacement use 25mm flat
glass gasket for the Flush Front, Masport part number
786774 or 10mm flat glass tape for the curved window
Masport part number 790229.
Gold-Plated Trim
The 24-carat gold plated finish on the trim requires
little maintenance, needing only be cleaned with a
damp cloth. DO NOT use abrasive materials or
chemical cleaners, as they will harm the finish and
void the warranty. Clean any fingerprints off before
turning the unit on. If the top louvres start to
discolour, check the glass gasket seal and replace
if necessary.
Glass Replacement
Your Masport stove is supplied with high temperature,
5 mm Neoceram ceramic glass that will withstand the
highest heat that your unit will produce. In the event
that you break your glass by impact, purchase your
replacement from an authorised Masport dealer only,
and follow our step-by-step instructions for
replacement.
Bay Glass Removal
1) Remove the window from the unit (refer to removal
instructions on page 10) and place on a soft
surface to prevent scratching.
2) Remove the nuts holding the glass retainers in
place.
3) Remove the glass retainers.
4) Replace the glass.
5) Reverse the previous steps, replace the retainers
and fasten with the nuts but do not over tighten, as
this can break the glass.
6) Refit the window to the fire and check the seal.
Flush Glass Replacement
Remove the glass by following the instructions on page
11. Fit the new glass, replacing the gaskets if
necessary.
Fan Maintenance
If your fan requires maintenance or replacement,
access to the fan is through the plate on the rear wall
of the firebox.
Note: The unit MUST NOT be operated without
the fan access panel securely in place.
To remove fan:
1) Turn the unit and/or pilot off and allow it to cool to
room temperature.
2) Unplug or disconnect the power source to the fire.
3) Remove glass front (see page 11).
4) Remove logs and embers (see page 12).
5) Remove the burner (2 screws at the front, refer to
diagram over page).
6) Loosen the screws securing the rear fan access
panel in place. Lift and withdraw the panel passing
the keyhole slots over the screw heads.
7) Remove the fan-shipping nuts.

Masport inbuilt gas fires Specifications

General

Brand	Masport
Model	inbuilt gas fires
Category	Indoor Fireplace
Language	English