Massimo MVR - Battery Indicator (if Equipped); Headlight Switch (if Equipped); Turn Signal Switch (if Equipped); Accelerator and Brake Pedals

INTRODUCTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Battery indicator (if equipped)
The battery indicator is on the dashboard.
The charge gauge identifies the remaining charge of the batteries in the battery pack. From top to bottom, the battery
power is getting less and less.
Headlight Switch (if equipped)
If the vehicle has headlights, the headlight switch is located on the dash panel
Turn Signal Switch (if equipped)
The turn signal switch is on the steering column and controls the operation of the right and left turn signal lights.
Accelerator and Brake Pedals
Accidental movement of the accelerator pedal can cause the vehicle to move suddenly and cause
severe injury or death.
When the key is on the position of the , When the forward/backward switch is in the FWD or REV position, and when
you press the accelerator pedal (10 or 15), the motor starts and the vehicle will move in the direction indicated by the
forward/backward switch. This vehicle is equipped with motor brake, when the accelerator pedal is released, the motor will
stop. To stop the vehicle quickly, press the brake pedal (9 or 14)
(Figure 1).
Horn button (if equipped)
The horn button is on the left side of the steering wheel. Press the button to activate
the horn.
Tow switch
On the right side under the seat pop （Figure 3）
Parking pedal
Hydraulic pedal
.
Owner’s Guide
27
This vehicle is equipped with a mechanical parking brake (2) (Figure 4). The parking
pedal has three positions. When the vehicle stops, please depress the parking pedal to
the third position, and turn the key switch to the third position and pull it out. The key
can be left. When starting the vehicle, please turn the key switch to the time, depress
the accelerator pedal (4) (Figure 4), the parking pedal (2) (Figure 4) and the brake
pedal (3) (Figure 4) will automatically bounce off, and then move forward and
backward. When the switch is pressed to FWD or REV, the vehicle can run in the
selected direction.
Figure 4 Parking pedal
Figure
5
Hydraulic
pedal
This vehicle is equipped with a mechanical brake pedal (Figure 5). When the vehicle is
stopped, please depress the parking pedal(5), turn the key switch to , and then
remove the key before leaving. When starting the vehicle, please turn the key switch
to ,, press the parking pedal(5), and the parking pedal(5) will automatically reset.
When the switch is pressed to FWD or REV, the vehicle can run in the selected
direction.
B
efore
s
tarting the vehicle, please check whether the
t
ow
switch
is in the No State.
The cart will not be able to move, please turn off the tow switch when you will not
start the vehicle for a long time.
The DS-A2-2 l6e model, need to sit on the driver seat, before switch on the ignition
ke
y, otherwise, the carts
cannot
have power,
Figure 3 Tow Switch