To Next PageTo Next Page
Need help?Do you have a question about the Mastech MS2108A and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Duty Cycle | 0.1% to 99.9% |
| Continuity | Yes |
| Diode Test | Yes |
| NCV | Yes |
| DC Current Range | 200μA to 10A |
| AC Current Range | 200μA to 10A |
| Capacitance Range | 20nF to 200μF |
| Frequency Range | 10Hz to 10MHz |
| Display | LCD |
| Temperature Range | -20°C to 1000°C |
General safety rules and checks upon delivery and storage.
Precautions for safe operation and measurement during device use.
Explanation of safety and operational symbols used in the manual.
Guidelines for meter maintenance and repair procedures.
Identification and listing of all parts of the digital clamp meter.
General specifications including auto range, protection, and environmental limits.
Detailed electrical specifications for current, voltage, and resistance measurements.
How to use the data hold function to freeze readings on the display.
Operation of the relative reference measurement mode.
How to switch between frequency and duty cycle measurements.
Selecting and displaying maximum or minimum measured values.
How to select different measurement functions and modes.
Operation of the display backlight and clamp lighting.
Explanation of the automatic power-off function to save battery life.
Steps to prepare the meter for taking measurements.
Step-by-step guide for measuring AC current using the clamp.
Step-by-step guide for measuring DC current using the clamp.
Procedure for measuring AC voltage using test leads.
Procedure for measuring DC voltage using test leads.
How to measure frequency using current clamp or voltage leads.
How to measure duty cycle using current clamp or voltage leads.
Procedure for measuring resistance with test leads.
Procedure for testing diodes using test leads.
Procedure for testing circuit continuity with a buzzer indication.
Procedure for measuring capacitance with test leads.
Instructions for safely replacing the meter's batteries.
Guidelines for replacing damaged test leads.
