10
Lowes.com/masterforge
ASSEMBLY INSTRUCTIONS
8. Attach the burner (E) to the bottom bowl (K) using
M6 x 15 mm large screw (CC).
Attach igniter wire (M) to burner (E).
Attach regulator/control knob (O) to burner (E).
Hardware Used
CC
M6 x 15 mm
Large Screw
x 1
6. Attach the left side handle (I), right side handle (L)
and heat plate supports (J) to the bottom bowl (K)
using two sets of two 6 mm heat resistant washers
(II), two 5 mm washers (GG), two 5 mm lock
washers (JJ) and two M5 wing nuts (EE).
Hardware Used
EE
M5 Wing Nut x 4
GG
5 mm Washer x 4
II
6 mm Heat
Resistant Washer
x 4
JJ
5 mm
Lock Washer
x 4
6
7. Attach left leg (P) and right leg (Q) to the bottom
bowl (K) using four sets of M6 x 15 mm large
screws (CC), 6 mm washers (HH) and 6 mm lock
washers (KK).
Hardware Used
CC
M6 x 15 mm
Large Screw
x 4
HH
6 mm Washer x 4
KK
6 mm Heat
Resistant Washer
x 4
7
8
To Next Page
Loading...
