Master Forge WK95C8M - Page 14

14
NOTE : DO NOT DISASSEMBLE THE STAINLESS STEEL
WICK HOLDER.
Hole
Pin
7/32 in. (5.5mm) All around
WICK 25/64 IN. (10 mm)
RIM OF WICK
ADJUSTER
(holder)
11. Install the new wick and insert the 3 pins on a new wick into
the 3 holes on the wick sleeve in the upward direction. (See the
arrow marked “▲ up” on
the wick sleeve)
12. Push the new wick into the retainer teeth of the wick
sleeve so that the wick adheres tightly around the inside of the
wick sleeve, smoothing out any wrinkles.
13. Line up the pins with the slotted holes inside the wick
adjuster. Then lightly press each of the three pins of the wick
(now attached to the wick sleeve) toward the center, away from
the slanted grooves of the wick adjuster allowing the wick do
drop slightly. Once the pins line up with each hole, press rmly
on each pin toward the slanted grooves securely through each
hole.
NOTE : Turn the wick adjustment knob and check to be sure that
the wick moves up and down freely.
14. The wick height will automatically be set to the correct
burning height of 3/8” (10mm).
NOTE : Be sure to check wick height. It should be 3/8”.
11
12
13
14
10
10. Remove the wick by folding it to the inside. Then remove the
wick sleeve from the bottom of the assembly.