Master Forge WK95C8M - Page 5

5
ASSEMBLY INSTRUCTIONS
3. Align the arrow marking on the top plate (AA) with
the carrying handle hole on the cabinet and place
the top plate on the heater (A).
Top Plate
x1
x1
x1
x1
Front guard
Carrying
handle
Rear guard
AA
DD
BB
DD
EE
Hardware Used
Hardware Used
Hardware Used
AA
3
carrying handle
hole
4
5
A
A
A
4. Hang the upper portion of the front guard (DD)
(notched to allow for the igniter door) on the Upper
Grill brackets with the downward hooked grill rods.
Snap the lower portion of the front guard into the
holes in the Lower Grill brackets with the inward
hooked grill rods.
Install the rear guard (EE) in the same way.
5. Insert the carrying handle (BB) into the holes on
the heater (A) by aligning holes on brackets of top
plate.
DD
Fig.8
Fig.9
Fig.6
Fig.7
Top Grill Screw
BB
arrow
marking