31
position.
2. Check the blade guard assembly.
3. Clean cutting tools with a gum and pitch remover.
4. To maintain the table surfaces and rails, periodically apply paste wax to
them and buff them in order to ensure smooth functioning. To prevent
work from slipping during cutting operations, DO NOT wax the working
face of the mitre gauge.
5. Protect the saw blade by cleaning sawdust out from underneath the saw
table and between the blade teeth. Use a resin solvent on the blade teeth.
6. Clean plastic parts only with a soft damp cloth. Do not use any aerosol
or petroleum solvents.
LUBRICATION
1. This saw’s motor bearings have been packed at the factory with proper
lubrication.
2. Clean screw threads and nuts with a solvent recommended for gum and
pitch removal.
3. Lubricate screw threads, nuts, and bearing points (including those on the
blade guard assembly and the mitre gauge).
LOOSE PARTS:
Blade guard………………………………………………………….. 1pc
Anti-kickback pawls…………………………………………….…... 1pc
Mitre gauge………………………………………………………….. 1pc
Rip fence…………………………………………………………….. 1pc
Handle Assembly……………………………………………………. 1pc
Push stick………………………………………………………….. 1pc
Blade wrench………………………………………………………. 2pcs
Hex key (5/32” [4 mm])………………………………..…….………. 1pc
Hex key (15/64” [6 mm])……………………………………..…….. 1pc
Dado throat insert…………………………………………..…….…. 1pc