13.AVOID KICKBACKS (work thrown back towards you) by keeping the blade sharp, the
ripfence parallel to the saw blade and by keeping the splitter, anti-kickback pawls and
guards in place, aligned and functioning. Do not release workpiece before it has passed
beyond the saw blade's cutting arc. Do not rip pieces that are twisted, warped or that do
not have a straight edge to guide it along the rip fence.
14.AVOIDAWKWARD OPERATIONS and hand positions where a sudden slip could cause
your hand to move into the saw blade.
15.NEVER USE SOLVENTS to clean plastic parts. Solvents could possibly dissolve or
otherwise damage plastic parts. Only a soft damp cloth should be used to clean plastic
parts.
16.MOUNT your table saw on a work bench or stand before performing any cutting
operations. Refer to ASSEMBLY instructions.
17.NEVER CUT METALS or materials which may make hazardous dust.
18.ALWAYS USE INWELL VENTILATED AREA. Remove sawdust frequently. Clean out
sawdust from the interior of the saw to prevent a potential fire hazard.
19.NEVER LEAVE THE SAW running unattended. Do not leave the work area until the saw
comes to a complete stop.
20. Forproper operation follow the instructions in this Instruction Manual (Page 23).
Failure to provide sawdust fall-through and removal hole will cause sawdust to build up
in the motor area resulting in a fire hazard and potential motor damage.
SAVE THESE SAFETY iNSTRUCTiONS
To Next Page
Loading...
Need help?
General
