25
Saw vibrates
or shakes.
Saw blade damaged Replace blade.
Saw blade loose Tighten blade screw.
Saw not properly fastened
down
Fasten saw to stand, bench,
or table.
Workpiece not properly
supported
Properly support or clamp
workpiece.
Laser line
projection is
hard to see.
Light in work area is too
bright
Move the Mitre Saw to a
work area with proper light.
Sawdust on the laser lens
Clean laser lens using a soft,
dry brush.
If the problem remains unsolved after performing the checks described
above, call the Toll-free Helpline, at 1-800-689-9928.
Repair Parts
INCLUDES:
• 1 Pc - 40T carbide-tipped blades
• 1 pc - hold down clamp
• 1 pc - dust collection bag
• 1 pair - extension rails
• 1 pc - wrench
• 1 pc - vacuum adaptor
To Next Page
Loading...
