MasterCraft GEN 2 - Installing the Actuator; Mount Actuator for X2; Mount Actuator for X25; Mount Actuator for Other Models

Technical Techniques
todrill.Alsomarktheoutlineoftheacutatorfootasyouwillneedthis
toinstallshims.
Step 22: Usingthe3/16”drillbit,drillallholes.Drillthecenterhole(forwiring)
withthe3/8”drillbit.
For X-25, continue with Step 23.
Installing the Actuator:
Step 23: For X-2 only: Assumingtheactuatorwasleftattachedtothetransom,
extendtheactuatorarmtotwithoutthelongbracketjustinstalledon
thesurftabplate.Using#12SSscrews,attachedtheactuator.
Step 24: For X25 only:Usingthepatterndrawnwithgreasepencilonthetran-
som,mountthe#530120actuatorshims,usingBostikorothermarine-
gradesealanttoholdinplace.Screwswillbeaddedaftertheactua-
torisinplace.
Step 25: For all models except X2:ApplyBostikorothermarine-gradesealant
tothebackoftheactuatorfoot.
Step 26: Mountonthetransom(orshimforX25),threadingthewiringthrough
theholeinthetransom.Installusing#12SSscrews.
GEN 2 Wake Shaping Devices Installation
(Replacing GEN 1) for X2, X10, X25,
X30, and X46
(Page 6)