SAFETY GUIDELINES AND MEASURES
6 August 2010 / SunMaster CS15TL/CS20TL / EN
2 SAFETY GUIDELINES AND WARNINGS
2.1 WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this
manual by the following pictograms:
A procedure, circumstance, etc which
deserves extra attention.
CAUTION!
Special information, commands and
prohibitions in order to prevent damage.
WARNING
A WARNING refers to possible injury to the
user or installer or significant material damage
to the CS15TL/CS20TL if the installer / user
does not (carefully) follow the stated
procedures.
2.2 USE FOR INTENDED PURPOSE
The CS15TL/CS20TL is constructed as per the applicable
safety-technical guidelines. Use the CS15TL/CS20TL only
in installations that meet the following qualifications:
• in permanent installations;
• connected to a separate, grounded three phase AC
group, to which no other electrical equipment is
connected;
• the electrical installation must meet the applicable
regulations and standards, must be carried out
correctly and must be in a good condition.
• according to the technical specifications as stated in
section 10.1.
WARNING
Never use the CS15TL/CS20TL in situations
where there is danger of gas or dust explosion
or potentially flammable products!
Use of the CS15TL/CS20TL other than as mentioned
under § 2.2 and 4.3 is not considered to be consistent with
the intended purpose. Mastervolt is not liable for any
damage resulting from the above.
2.3 ORGANISATIONAL MEASURES
The installer / user must always:
• have access to this manual;
• be familiar with the contents of this manual. This
applies to Chapter 2, Safety Guidelines & Warning
particularly.
2.4 INSTALLATION, MAINTENANCE, REPAIR
WARNING
As dangerous voltages exist, only allow
installation, maintenance and repair of the
CS15TL/CS20TL and changes in your
electrical system to be carried out by qualified
electricians.
Connections and safety features must be executed
according to the locally applicable regulations.
In case of decommissioning and/or demounting follow the
instructions as stated in section 6.8.
If such are required, only use original spare parts.
2.5 WARNING OF SPECIAL DANGERS
Two primary energy sources are present:
solar panels (DC) and grid (AC)! Switch off
both sources before starting any work on the
installation. Block the switching device against
unintentional switching. Verify de-energizing
of both DC and AC connections using a
suitable metering instrument.
The voltages (up to 1000V) present at the grid
and solar side of the CS15TL/CS20TL are not
safe to touch.
Make sure two persons are present when
working on an installation, at least until the
installation has been de-energized and
verified by a suitable metering instrument.
To Next Page
Loading...
Need help?
General
