14
4.4 Operation After Storage
Before the machine is started up, check the following items regularly:
Check oil level and add it if not enough.
Check and tighten all screws and nuts;
Check the regulated state of the machine.
Check the blade state.
Check the air hole on the gearbox. If it is blocked, clean or open the hole with compressed
air.
Don’t spread oil or grease on the driving belts. If there is oil or grease on the belts, wipe the
belts, in case the belt sliding and wearing occur.
ATTENTION: Check the machine every 10 hours. Repair the
damaged parts or replace the blade according to
the manufacturer’s recommendation, to keep the
machine balancing.
Check all tightening parts and replace them if necessary.
Don’t remove the protective parts on some points and protect the machine.
ATTENTION: In the case of vibration, stop the machine and
check the blade. If the blade breaks or is
damaged, replace it with same type of the blade.
If the machine vibrates still, send the machine to
the authorized repairer.
To Next Page
Loading...