7
CHAPTER Ⅲ OPERATION
CAUTION: Be familiar with the machine before starting. Read
this manual carefully to learn how to operate the
machine safely and how to set it to provide
maximum field efficiency.
3.1 Checking Before Operating
ATTENTION: Only use universal joint conforming to CE
standard and protect them properly.
Before operating the machine, the following areas should be checked off:
1. Before starting up the machine, check and Lubricate all grease points, all lubricated
parts inside the machine.
2. Use only an agricultural tractor of horsepower within limits of the machine specified.
3. Check that the machine is properly attached to the tractor. Be sure retainers are used
on the mounting pins.
4. Be sure extra weights are mounted on the front of the tractor.
5. Check the oil level in the gearbox. Add as required.
6. Check that the tractor PTO shaft turns freely and that the machine driving shaft can
telescope easily.
7. Check the blades. Be sure they are not damaged or broken and swing freely in their
mount. Repair or replace as required.
8. Check and tighten the blade bolts.
9. Check for entangled material in all rotating parts. Remove this material.
10. Install and secure all guards, doors and covers before starting.
11. Before installing the universal joint, the tractor and the machine motor shall be
stopped and the key be taken away. The universal joints shall be installed in good
state, with proper protective parts.
12. The chain on the protective parts of the universal joint shall be guaranteed in good
condition, in case, automatic rotation occurs.
13. All other persons shall leave the ground before connecting the driving power from the
To Next Page
Loading...