8
tractor. Keep the output of the tractor at 540 RPM.
14. Before cleaning, repairing and lubricating the machine, stop the motor and take away
the key with you.
15. When the universal joint is not connected with the tractor, they must be connected
again through the frame to protect the joint from damaging.
16. Don’t approach the machine when the machine runs.
3.2 Adjusting the Height
In order to conduct a precise work, the machine shall be operated according to the
recommended cutting height.
For saving fuel and power, and reducing the wear of the machine, the cutting height must be
regulated correctly.
When regulating the working height, loosen the screw (1), remove the screws (2) on both
sides; regulate the roller height (see following drawing); fix the parts on the set position. The
lowest hole is the highest working height; put the screws (2) into the set hole; tighten screw
(1) and screws (2).
2
1
To Next Page
Loading...