Matrix 7xe - 9.5 7 XE TFT-LCD Module Replacement

45
9.5 7XE TFT-LCD MODULE REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1. Remove the UCB as outlined in Section 9.4.
2. Cut the two ties on the fixing plate (Figure A).
3.
Remove the fixing plate set from the console cover (Figure C).
4.
Remove the 4 screws
holding on the TFT- Panel. Remove the UCB (Figure D).
5. Unplug the Inverter cable and LVDS cable (Figure E).
6.
Note: There are two holes on the panel fixing plate--the upper hole is for 7xe and the
lower hole is for T7xe (Figure F).
FIGURE DFIGURE C
FIGURE BFIGURE A
FIGURE FFIGURE E