Matrix 7xe - 7 Xi TFT-LCD Module Replacement

49
9.9 7XI TFT-LCD MODULE REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1. Remove the UCB as outlined in Section 9.7.
2. Cut the tie and remove the Tuner set on the fixing plate (Figure A).
3.
Remove the touch panel tie
holding on the fixing plate (Figure B).
4.
Remove the fixing plate set from the console cover (Figure C).
5.
Remove the 4 screws
holding on the TFT- Panel (Figure D).
6. Unplug the Inverter cable and LVDS cable (Figure E).
FIGURE DFIGURE C
FIG
URE BFIGURE
A
FIGURE E