Matrix ETERNITY Quick Start 73
Door Phone Card
• The Door Phone Card in ETERNITY PE is used for operating gadgets and door
phones.
• If you have connected a Door Phone to the door phone port, go to ‘Door Phone’
to program the door phone related parameters.
• If you have connected a relay-based device like a Door Lock, a hooter or a
siren, or any other automated control application, first go to ‘DOP’ under
System Parameters and program the port.
• Similarly, go to ‘DIP’ under System Parameters to program the Digital Input Port,
if you have connected any sensor device.
• If you have connected any gadget that you want to operate remotely, using a
command, or a timetable, or based on a timer, go to ‘Automated Control
Applications’ to program the relevant parameters.
• Please read the topics Digital Output Port, Digital Input Port, Door Phone and
Automated Control Applications in the System Manual before configuring the
Door Phone Card.
• To exit the SE programming mode in Jeeves, click ‘Logout’ button at bottom of
the browser window.
VMS Card
• The ETERNITY automatically assigns un-used SLT software ports (SLT ports
which are not assigned any hardware slot-port) as VMS port.
• The SLT software ports used by VMS card automatically get configured in
Routing Group number 96.
• The ETERNITY automatically assigns Routing Group number 96 as VMS
Group.
• Default access code of the VMS group is 3931, You may change this access
code on the ‘Access Codes’ page of Jeeves.
• To land incoming calls on VMS, program Routing Group 96 as Trunk Landing
Group (TLG) in the trunk feature template assigned to the respective trunks.
To Next Page
Loading...
