Matrix MW401 User Manual

6
Salt and rinse aid warning lights and end of programme light (5)
When the dishwasher salt or rinse aid begins to run out, the warning light
will illuminate to advise that it needs refilling.
When the programme is complete, the dishwasher will emit five beeps and
the end of programme indicator light will illuminate.
Starting a programme
•Press the Power button (the end of programme light will be switched on)
•Press the Programme Selection button until the required programme is
shown on the display.
•Once a programme is selected, the end of programme light will switch
off.
•When you close the dishwasher door, the programme will start
automatically.
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme, simply press
the Programme Selection button.
At the end of a programme
If possible, do not open the dishwasher door once the programme has
started.
At the end of a programme, the dishwasher will beep five times, and the
end of Programme Indicator light will switch on.

Matrix MW401 Specifications

General

Door color	Not applicable
Built-in display	Yes
Appliance placement	Fully built-in
Control panel color	Stainless steel
Cycle time	160 min
Noise level	52 dB
Delayed start timer	-
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	12 place settings
Number of washing programs	4
Washing class	A
Annual water consumption	3360 L
Annual energy consumption	273 kWh
Current	13 A
Power consumption (off)	0.05 W
Water consumption per cycle	12 L
Energy consumption per cycle	0.95 kWh

Weight and Dimensions

Width	- mm