Matrix MW401 User Manual

7
Changing a programme
It is possible to change the programme if necessary once the programme
has started.
•First open the door slightly to reduce the risk of water spillage.
•Press the programme selection button until the required programme is
shown on the display.
•Then close the door. The dishwasher will begin the new programme
from the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel the programme once is has started.
•First open the door slightly to reduce the risk of water spillage.
•Press and hold in the Programme Selection button until the end of
programme indicator flashes.
•Then close the door. The dishwasher will run a drain cycle which will take
approximately 30 seconds. Once this is complete, the dishwasher will
beep five times and the end of programme light will switch on.
Switching the dishwasher off
•Once the dishwasher beeps five times and the end of programme light
switches on, the dishwasher can be switched off by pressing the Power
button.
•Then turn off the water tap and remove the plug from the power socket.
Please note: the dishwasher will automatically continue on the
programme it has started if the door is opened or in the event of a
power cut.

Matrix MW401 Specifications

General

Door color	Not applicable
Built-in display	Yes
Appliance placement	Fully built-in
Control panel color	Stainless steel
Cycle time	160 min
Noise level	52 dB
Delayed start timer	-
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	12 place settings
Number of washing programs	4
Washing class	A
Annual water consumption	3360 L
Annual energy consumption	273 kWh
Current	13 A
Power consumption (off)	0.05 W
Water consumption per cycle	12 L
Energy consumption per cycle	0.95 kWh

Weight and Dimensions

Width	- mm