Matrix MW401 User Manual

8
Detergent
To fill the detergent compartment
1. Push the latch to open the
compartment.
2. Add the required amount of detergent.
The main detergent compartment “b”
(figure 2) has lines to allow for specific amounts of detergent. These are
marked at either 15 cm
3
or 25 cm
3
, to be used depending on how dirty
the dishes are.
If your dishes are in need of an intensive wash, then add 5 cm
3
of
detergent into the prewash section of the compartment “a”
(figure 1).
3. Then close the detergent compartment lid until the latch locks.
Please note: You should only use detergents designed specifically
for use in dishwashers.
If using dishwasher tablets, always use the detergent compartment, do not
put them in the main body of the dishwasher or in the cutlery basket. The
solubility of dishwasher tablets can vary depending on the temperature and
duration of the programme. As a result, it is recommended that powder
detergents should be used in the shorter programmes to allow better
performance.
The use of separate detergent, rinse aid and dishwasher salt is
recommended rather than combination tablets as separates achieve better
wash performance.
Fig. 2

Matrix MW401 Specifications

General

Door color	Not applicable
Built-in display	Yes
Appliance placement	Fully built-in
Control panel color	Stainless steel
Cycle time	160 min
Noise level	52 dB
Delayed start timer	-
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	12 place settings
Number of washing programs	4
Washing class	A
Annual water consumption	3360 L
Annual energy consumption	273 kWh
Current	13 A
Power consumption (off)	0.05 W
Water consumption per cycle	12 L
Energy consumption per cycle	0.95 kWh

Weight and Dimensions

Width	- mm