Matrix S-Drive - 5.3 REAR ROLLER REPLACEMENT

11
5.3 rear roller rePlacemenT
1)Removethetwoscrewsholdingonthesupporttubesetandmovethesupporttubesetout(FigureA).
2)Removethescrewholdingontheendcapandremovetheendcap(FigureB).
3)Removebothrolleradjustmentscrews(FigureC).
4)Removetherollerfromtherunningbelt(FigureD).
5)ReverseStep1-4toinstallanewrearroller.
6)TensiontherunningbeltasoutlinedinSection2.3.
fiGUre c
fiGUre D
cHaPTer 5: ParTS rePlacemenT GUiDe
fiGUre a
fiGUre b