Matrix S-Drive - 5.8 ECB REPLACEMENT

18
5.8 ecb rePlacemenT
1)Removethe2screwsholdingframecover(FigureA).
2)Removethe4screwsonflywheelcover(FigureB).NOTE:Onescrewisatthebottomofthecover.
3)Removethe2screwsfromECB(FigureC).
4)TakeoffthesteelcablefromECB(FigureD).
5)ReverseStep1-4toinstallanewECB.NOTE:WhenyoufixECB,makesuretheinsidespringisattheECBscrewrightside(FigureE).
fiGUre c
fiGUre D
cHaPTer 5: ParTS rePlacemenT GUiDe
fiGUre a
fiGUre b
fiGUre e