Matrix S-Drive - Page 19

17
5.7 fronT roller rePlacemenT - conTinUeD
7)Removethefrontrollermountingscrews(FigureH).
8)Removetherollerfromtherunningbelt(FigureI).
9)ReverseStep1-8toinstallanewfrontroller.NOTE: When you install the new front roller, please make sure the roller housing is parallel
with the tube.
10)TensiontherunningbeltasoutlinedinSection2.3.
11)Whenyourunthebelt,theflywheelringmaytouchECBmagnetandmakenoise.PleaseloosentheECBscrewandadjusttheflywheel
ringbetweentwomagnetsandfixscrew(FigureK).
fiGUre j
fiGUre k
cHaPTer 5: ParTS rePlacemenT GUiDe
fiGUre H
fiGUre i