Matrix S-Drive - 6.3 ASSEMBLY INSTRUCTIONS

20
cHaPTer 6: TreaDmill SPecificaTionS anD aSSembly GUiDe
6.3 aSSembly inSTrUcTionS
B
A
There are no screws holding on the motor cover. OpenBlueAssemblyBag.Slidetheurethanearmsoverthesteel
tubes on the console base. Fasten the urethane arms to the steel
tubes using item 17 socket head cap screw and item 19 spacer.
STeP 1 STeP 2
BlackHardwareBags(x2)
Description Qty
A
B
Bolt
Flat Washer
4
4
Note:
Do not fully tighten hardware until the end of
step 5.
Step2TorqueValue:78.4Nm/57.8ft-lb