Matrix S-Drive - 5.2 SIDE RAIL REPLACEMENT

10
5.2 SiDe rail rePlacemenT
1)Removethetwoscrewsholdingonthesupporttubesetandmovethesupporttubesetout(FigureA).
2)Removethescrewholdingontheendcapandremovetheendcap(FigureB).
3)Loosenthefourscrewsundertheframeofthesiderail(FigureC).
4)Slidetherailtobackofthetreadmill(FigureD).
5)ReverseStep1-4toinstallanewsiderail.NOTE: After reinstalling the side rail, make sure the end cap is on first before tightening the
screws for proper gap spacing. Also be careful not to overtighten the screws, or they will poke through the top of the side rail.
fiGUre c
fiGUre D
cHaPTer 5: ParTS rePlacemenT GUiDe
fiGUre a
fiGUre b