Matrix SATATYA Devices Manual 77
1. Switch off the power supply of the unit. Unplug the power adapter, if you have connected it to SATATYA HVR.
2. Remove the upper cover from the SATATYA HVR. The top cover screws are located on the rear panel and the
side panels on HVR16/8 as shown below. Remove the top cover screws and slide open the cover.
HVR16/8P (HVR 1624P and HVR 0824P)
3. For HVR16/8P, take the Clamp and Place the Hard Disk inside the Clamp as shown below. Secure the hard disk
inside the Clamp with the four screws provided using a magnetic screw driver.
Maximum torque to be applied for tightening the screws is 3 kgf.cm. Applying more than specified torque will
cause a damage to the HDD and the clamp.
TOP COVER SCREWS
REAR VIEW
To Next Page
Loading...
