Matrix SATATYA PARAM NVR8S User Manual

66 Matrix SATATYA NVR Quick Start
Click DHCP Server, the DHCP Server Settings page appears:
• Select the Enable DHCP Server check box.
• Select the desired Ethernet Port — LAN 1, LAN 2— which will be used for dynamic
assignment of IP Addresses to the DHCP Clients (IP cameras).
LAN1 and LAN2, will be displayed if the NVRX/NVRX P2 installed supports two ports.
In LAN 1 Settings if the IP Assignment Mode is set as DHCP or PPPoE, then LAN 1 will be
disabled.
•Enter the Start IP Address. It is the starting IP Address to be assigned to the DHCP
Clients. The DHCP Server will start assigning IP Addresses to the DHCP Clients from
this IP Address onwards.
• Enter the Number of Hosts (that is the number of clients) to be assigned IP Addresses
by the DHCP Server.
•Enter the Subnet Mask to be assigned to the DHCP Clients.
•Enter the DNS Address to be assigned to the DHCP Clients.
•Enter the Lease Hours. This is the maximum time for which the IP Address will be
allocated to the DHCP Client. Valid Range: 1 to 192 hours. DHCP Clients should renew

Matrix SATATYA PARAM NVR8S Specifications

General

Brand	Matrix
Model	SATATYA PARAM NVR8S
Category	Security System
Language	English