16 Matrix SATATYA NVR Quick Start
NVR3204X/NVR6404X/NVR3204X P2/NVR6404X P2
•1 Cable Mains 3 Pin
• 16 HDD fitting screws
•4 HDD SATA Cable
•2 Clamps for Rack Mounting
NVR6408X/NVR6408X P2/NVR9608X P2
•1 Cable Mains 3 Pin
• 32 HDD fitting screws
•8 HDD SATA Cable
•2 Clamps for Rack Mounting
Things You Will Need
• A Power Hand Drill
• A Wire Stripper
• Insulation Tape
• A Screwdriver set
• Cameras (IP Cameras, PTZ cameras).
• Monitors (HDMI) with the appropriate cables to connect.
• At least one SATA Video Surveillance Hard Disk (upto 10TB), if you want to record on a hard
disk in the NVR. You can install eight hard disks.
• A USB Mouse or Keyboard (Wired or Wireless) to operate the NVR, if required.
• A personal computer or a LAN computer with a browser installed on it (Internet Explorer,
Mozilla Firefox, Google Chrome), if you want access the NVR from a remote location.
• Any audio device you want to connect with cables.
• An Ethernet cable to connect to a computer/LAN/WAN (over a DSL Modem or Router).
• Insulated copper wires (wire range: 28-16 AWG, 0.5 -1.5mm
2
), if you want to connect
sensor and alarm devices.
• A rack, if you want to mount the NVR on a rack.
Preparing for Installation
• Select a suitable location after reviewing your video surveillance layout requirements, cable
runs and power needs.
• The SATATYA NVR is meant for indoor installations only.
• The SATATYA NVR unit can be mounted on a rack or placed on any stable flat surface
such as a desk.
To Next Page
Loading...
Need help?
General
