Ethernet
12V DC @2A
Audio IN
Audio Out
Alarm IN
Alarm Out
Accessing Reset Switch and SD card slot
If you forget the IP address or login credentials of camera then the camera
can be reset to factory default settings using the reset switch.
To access the Reset switch
1. Open the retainer screws and remove the lens cover, see Figure 10.
2. The Reset switch is located near the lens, see Figure 14. Press the
Reset switch for minimum 5 sec and release the switch to reset the
camera to default settings.
3. You can insert the SD card in the slot to store your camera recordings,
see Figure 14.
SD Card Slot
Reset Switch
22
21
If devices such as Mike and Speaker can be connected to
Audio IN and Audio OUT, you may need to connect an external
power source if their power requirements are not fulfilled with
the camera adapter.
If devices such as Sensor and small Buzzers can be connected
to Alarm IN and Alarm OUT, you may need to connect an
external power source if their power requirements are not
fulfilled with the camera adapter.
After Reset or SD card insertion, you may need to set the
camera focus and camera angle.
To Next Page
Loading...