Step 4: Mounting the Camera
Figure 3
A. On Wall/Ceiling
• Stick the Mounting Template on the desired installation surface.
• Drill three 7.5mm diameter holes through the markings of the
Mounting Template on Wall or Ceiling. (Drill 50mm diameter hole
also if installing on false ceiling)
• Insert the screw grips in the holes you drilled.
Step 3: Installing Mounting Template
Mounting Ring
Mounting Template
7.5mm
diameter
50mm
diameter
• Align the screw holes on the base plate with those you drilled on
the installation surface.
• To avoid cable damage, take the Power, Ethernet, Audio IN,
Audio OUT, Alarm IN, Alarm OUT cables of the camera through
the cable hole on the base plate, see Figure 3.
• If the cabling is concealed, prior to the installation pull the cable
off the hole drilled on the installation surface.
• Now secure the base plate of the camera to the mounting ring.
Interlock the mounting ring slit to the groove on the base plate,
see Figure 4.
• Turn the camera body clockwise to fit in the slit of mounting ring.
• Finally fit the base plate with three M3x4 Grub screws, see
Figure 5.
Figure 2
10
9
To Next Page
Loading...