EasyManuals Logo
Home>Matrix>IP Camera>SATATYA Project Series

Matrix SATATYA Project Series User Manual

Matrix SATATYA Project Series
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
FCC Compliance
47CFR FCC PART 15B
Information to the user
(a) For a Class B digital device or peripheral, the instructions furnished the user
shall include the following or similar statement, placed in a prominent location in
the text of the manual:
NOTE: This equipment has been tested and found to comply with the limits of
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
FCC
Ÿ Reorient or relocate the receiving antenna.
Ÿ Increase the separation between the equipment and receiver.
Ÿ Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Ÿ Consult the dealer or an experienced radio/TV technician for help.
2011/65/EU (As per standard
EN 50581:2012)
EMC Directive
Vibration (sinusoidal)
Protection against Mechanical
impact (IK 10)
Degree of Protection (IP66)
2014/30/EU
Low Voltage Directive
2014/35/EU
IEC 60068-2-6 :2007
IEC 62262:2002
IS/IEC 60529:2001
RoHS Recast (RoHS 2)
Mechanical
Compliance
At the end of product life cycle; batteries, soldered boards, metal
components and plastic components must be disposed through
recyclers.
If you are unable to dispose-off the products or unable to locate e-waste
recyclers, you may return the products to Matrix Return Material
Authorization (RMA) department.
Disposal of Product after End-Of-Life
The product refered is covered by the waste Electrical and Electronic
Equipment (WEEE) directive and must be disposed of in a responsible
manner.
WEEE Directive 2002/96/EC
32
31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Matrix SATATYA Project Series and is the answer not in the manual?

Matrix SATATYA Project Series Specifications

General IconGeneral
BrandMatrix
ModelSATATYA Project Series
CategoryIP Camera
LanguageEnglish

Related product manuals